Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
Like Tree21Likes

Thread: Brush abuse

  1. #11
    Senior Member ZipZop's Avatar
    Join Date
    Jun 2017
    Location
    Honolulu
    Posts
    1,337
    Thanked: 204

    Default

    Quote Originally Posted by DZEC View Post
    I suggest you invest in a couple of cheap plastic brush holders that will allow you to store the brushes bristles facing down while they dry. That way they will dry more quickly and the bottom of the knot won’t be wet for very long.
    Superb suggestion. I invested in one of these for every brush I use regularly. I have six of them on my shaving shelf. After rinsing, the brushes go in these holders for drying. Simple, inexpensive, and effective.
    "I get some lather and lather-up, then I get my razor and shave! Zip Zop, see that? My face Is ripped to shreads!"

  2. #12
    Skeptical Member Gasman's Avatar
    Join Date
    Nov 2016
    Location
    Colorado Springs
    Posts
    10,474
    Thanked: 2182

    Default

    Hanging or standing has been an arguement for decades. I stand mine. Rince why running my finger thru the knot but not deep, shake out excess water in the shower, strop the knot on a towel gentle. I never spay my knot any more than a third of the way down. Shake it out one more time at my naked leg. If i get water on my leg i strop it again. Stand it up in the large closet i keep my software in until the next shave.

    Splaying deep or bending the hairs sharply at the glue will break them or cause them to get weak in turn will break them off sooner than later. I have 12 brushes and dont have any issues with loosing hairs unless its a new brush. Than you might loose a few at first, but it should sto0 after a half dozen uses.

    JMO.
    Paulbuck likes this.
    It's just Sharpening, right?
    Jerry...

  3. #13
    The Hurdy Gurdy Man thebigspendur's Avatar
    Join Date
    May 2005
    Location
    New Mexico
    Posts
    32,737
    Thanked: 5016
    Blog Entries
    4

    Default

    Probably the worse thing for a brush is to push it down hard into the soap to load it along with using water that is too hot or some severe cleaning solution. I always fan my brushes after they are dry and none have any issues at all.

    Usually after use they are rinsed thoroughly and I squeeze gently during the process. Then I shake them out real good and put them bristles down to dry. I have no issues with this process.

    Except for one synthetic they are all badgers.
    No matter how many men you kill you can't kill your successor-Emperor Nero

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •