Page 1 of 3 123 LastLast
Results 1 to 10 of 23
Like Tree3Likes

Thread: 5/8 or 6/8?

  1. #1
    Junior Member
    Join Date
    Dec 2011
    Location
    Houston,TX
    Posts
    4
    Thanked: 0

    Default 5/8 or 6/8?

    This is going to be my first straight, should I go with a 5/8 or 6/8? Pros and Cons of both would be nice, thanks.

    Mike

  2. #2
    Know thyself holli4pirating's Avatar
    Join Date
    Feb 2008
    Location
    New York
    Posts
    11,930
    Thanked: 2559

    Default

    I honestly don't think it matters. A smaller razor may be a little easier to move around your face, but not everyone would agree with that. A larger razor may make it a little easier to watch your shaving angle, but not everyone would agree with that.

    I think anything in the 5/8 to 6/8 range is good for a starter.
    cpcohen1945 likes this.

  3. #3
    Senior Member blabbermouth kalerolf's Avatar
    Join Date
    Jan 2010
    Location
    Amsterdam Holland
    Posts
    2,124
    Thanked: 246

    Default

    5/8 is a good size to start with.
    later you can always go to a bigger size
    First learn to shave, buy a first 5 / 8 from the Classifields here on SRP

  4. #4
    At this point in time... gssixgun's Avatar
    Join Date
    Jun 2007
    Location
    North Idaho Redoubt
    Posts
    26,947
    Thanked: 13221
    Blog Entries
    1

    Default

    Keep in mind this is just a personal opinion... Either will do fine IF they are truly shave ready

    but

    A 6/8 is a bit heavier and that sometimes helps with those first tentative shaving attempts
    The 6/8 can also help with keep the blade flat while stropping when you are new, and later on a 6/8 can be easier on the hones for the same reason


    Again this is JMHO and either will do fine...

  5. #5
    Not with my razor 🚫 SirStropalot's Avatar
    Join Date
    Oct 2011
    Posts
    1,859
    Thanked: 568

    Default

    This is from a little different perspective. This was never going to happen to me, HA! Dropped my stainless the 2nd week I had it and it hit the rounded edge of the sink and put the nicest little smile you've ever seen right in the middle of the blade. By the time I honed that out it was closer to 4/8 then the 5/8. If you start with 6/8's and the "this is never going to happen to me" happens you'll have more metal to work with.

    Regards,

    Howard

  6. #6
    Senior Member karlej's Avatar
    Join Date
    Oct 2011
    Location
    Standish, Maine
    Posts
    816
    Thanked: 952

    Default

    I'm still pretty new to the Straight. My first month of shaving was with a 5/8 Dovo. I then got a 6/8 Revisor. From my experience I concur with gssixgun. I found the extra weight of the 6/8 helped me keep the blade moving and the angle was easier to maintain. I see a lot of recommendations for having 2 razors to start. You might try one of each.
    Good luck and keep cruising these forums. Tons of good info and helpful folks.

  7. #7
    ace
    ace is offline
    Senior Member blabbermouth ace's Avatar
    Join Date
    Dec 2010
    Location
    Virginia
    Posts
    3,362
    Thanked: 581

    Default

    You'll find as you begin your journey that there are plenty of variables to be concerned about. The eighth of an inch between 5/8 and 6/8 is not one of them.

  8. #8
    Senior Member blabbermouth JimmyHAD's Avatar
    Join Date
    Feb 2008
    Posts
    32,564
    Thanked: 11042

    Default

    I agree with all that has been said. I find that when I look at the razors online I always gravitate toward the larger blade. When I'm actually shaving I like the maneuverability of the 5/8. It just handles nicely. The 6/8 does too though. Almost six of one half dozen of the other.
    Be careful how you treat people on your way up, you may meet them again on your way back down.

  9. #9
    Member AFDavis11's Avatar
    Join Date
    May 2005
    Location
    Virginia
    Posts
    5,726
    Thanked: 1486

    Default

    I prefer 6/8, but for reasons that are not attributable to "size", but rather weight and shank width. I strongly recommend you look for a razor with thin/ light scales.

    A5/8 that was half hollow and had a substantial shank would be just as good as any 6/8

  10. #10
    Senior Member Str8nSharp's Avatar
    Join Date
    Sep 2011
    Location
    Tampa
    Posts
    367
    Thanked: 20

    Default

    I have one 5/8 and two 6/8 and I don't use the 6/8 anymore, they serve as backups. I do find I like the 5/8 better overall, it gives me more of a tactical feed back, such as it starts to stick and I can feel it better and reposition the blade where heavier blades will go on through with momentum. All in all it's a ymmv.

Page 1 of 3 123 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •