Page 1 of 3 123 LastLast
Results 1 to 10 of 23

Thread: SMALL CHIP

  1. #1
    Junior Member fatpanda's Avatar
    Join Date
    May 2009
    Location
    West Lafayette, IN
    Posts
    184
    Thanked: 22

    Default SMALL CHIP

    A sad day... I ended up realizing that I put a very small chip on the very end of the edge of my blade near the toe. I went to rinse my razor and I looked in the mirror for a SPLIT second and ting!!! I bumped the bottom of the faucet right where the water comes out. This chip is incredibly small but I am suspect that it is the source of the worst razor burn I have ever felt.

    Is there anything that I can do or is this razor going in its coffin until the next honing? The chip/dent/ding is on the very extreme end of the edge. Any help will be appreciated, Thank you!

  2. #2
    The original Skolor and Gentileman. gugi's Avatar
    Join Date
    Aug 2007
    Posts
    17,410
    Thanked: 3906
    Blog Entries
    1

    Default

    yeah, it needs to be honed

  3. The Following User Says Thank You to gugi For This Useful Post:

    fatpanda (07-21-2009)

  4. #3
    Antipodean
    Join Date
    May 2009
    Location
    Dunedin, New Zealand
    Posts
    522
    Thanked: 137

    Default

    Agreed, it'll need honing for sure. I dodged a bullet the other day - did the exact same thing as you, but fortunately it was the spine that hit the tap, not the edge. I said a thankful prayer to the razor gods that night for sure!

  5. The Following User Says Thank You to mosley59 For This Useful Post:

    fatpanda (07-21-2009)

  6. #4
    Junior Member fatpanda's Avatar
    Join Date
    May 2009
    Location
    West Lafayette, IN
    Posts
    184
    Thanked: 22

    Default

    Bad News... Thanks guys. It looks like the coffin it goes!

  7. #5
    Senior Member
    Join Date
    Mar 2009
    Location
    Sussex, UK
    Posts
    1,710
    Thanked: 234

    Default

    Ah, welcome to the not-so-exclusive club of 'I dinged my razor on the Faucet!'

  8. #6
    Junior Member
    Join Date
    Jun 2009
    Location
    Silver Spring, MD
    Posts
    11
    Thanked: 1

    Default

    I had the same thing happen to an expensive new razor and sent it to the ClassicShaving.com razor repair service. It cost me $30 and I should be getting it back any day now. It may be worth the try.

  9. The Following User Says Thank You to garciaoz For This Useful Post:

    fatpanda (07-21-2009)

  10. #7
    Senior Member BHChieftain's Avatar
    Join Date
    Mar 2009
    Location
    San Jose, CA, USA
    Posts
    509
    Thanked: 108

    Default

    You are certainly not the first person to do this!

    My rule when I shave is never to take my eyes off the razor, esp. when rinsing or changing hands...

    -Chief

  11. The Following User Says Thank You to BHChieftain For This Useful Post:

    fatpanda (07-21-2009)

  12. #8
    Stubble Slayer
    Join Date
    Jan 2009
    Location
    Alexandria, VA
    Posts
    708
    Thanked: 171

    Default

    I would bet almost everyone does this at least once. I also think most people learn from it and don't repeat

    I definitely did it once when starting off, and I haven't done it since. I rinse much lower and I'm much more careful around the faucet.

  13. #9
    Junior Member fatpanda's Avatar
    Join Date
    May 2009
    Location
    West Lafayette, IN
    Posts
    184
    Thanked: 22

    Default

    I think I will never take my eyes off the razor when it is open again. Seems like such a common mistake! I think I have learned some respect for how delicate the edge of a razor is. I guess I am too used to throwing steak knives in the sink after a meal...

  14. #10
    Senior Member
    Join Date
    Apr 2009
    Location
    Arizona
    Posts
    325
    Thanked: 127

    Default

    Oooouch!!! Not a good way to start the day. As a general rule I NEVER EVER take my eyes off the blade once I open it and put it in my hand, even then I have come close to doing the same thing. Sorry for your loss.

    Ray

  15. The Following User Says Thank You to rayman For This Useful Post:

    fatpanda (07-21-2009)

Page 1 of 3 123 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •