Results 1 to 3 of 3
  1. 03-05-2009, 01:53 AM #1
    tomandjerry00
    tomandjerry00 is offline
    Member
    Join Date
    Dec 2008
    Location
    Washington, DC
    Posts
    76
    Thanked: 9

    Default How to sand and finish a strop?

    Of course learning to strop, I took a few good nicks out of my strop and was wondering how to refinish it. I know I need to sand, but to what grit and what do I do after sanding? Thanks a lot!
    Reply With Quote Reply With Quote
  2. 03-05-2009, 02:32 AM #2
    gugi
    gugi is offline
    The original Skolor and Gentileman. gugi's Avatar
    Join Date
    Aug 2007
    Posts
    17,410
    Thanked: 3906
    Blog Entries
    1

    Default

    pumice stone seems to work quite well.
    Reply With Quote Reply With Quote
  3. 03-05-2009, 04:11 AM #3
    AusTexShaver
    AusTexShaver is offline
    Senior Member AusTexShaver's Avatar
    Join Date
    Sep 2008
    Posts
    359
    Thanked: 72

    Default

    If you are planning to sand the entire strop what grit will depend on what sort of draw you want. As a general rule the coarser the grit the rougher the surface and the more the draw. I'm partial to 400 grit but you will just have to experiment to see what feels best for you.

    As for what to do next...you should clean it and condition it.

    I'm partial to Lexol products and use their cleaner first and follow up with the conditioner.
    Reply With Quote Reply With Quote

  4. The Following User Says Thank You to AusTexShaver For This Useful Post:

    tomandjerry00 (03-05-2009)
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules