Results 1 to 8 of 8
Like Tree12Likes
  • 3 Post By billyc4362
  • 3 Post By billyc4362
  • 1 Post By MickR
  • 3 Post By Alembic
  • 1 Post By Alembic
  • 1 Post By billyc4362

Thread: Wet Shave Part II- The Sequel!

  1. #1
    Senior Member billyc4362's Avatar
    Join Date
    Aug 2013
    Location
    Philadelphia, PA
    Posts
    139
    Thanked: 5

    Default Wet Shave Part II- The Sequel!

    Wet shave II is officially in the books! A little better than wet shave 1, but still a long way to go. I'm still trying to get the hang of the correct angle. Sometimes I feel like Im mearly wiping the soap off with the spine, or the blade is tugging the hair too much. I can tell you where I am consistent- I cut myself on the same spot on my face as I did on the first shave- LOL! About 1 inch away and 1 inch above my right earlobe. I'm lefthanded, you see.

    Even though I'm not getting the results that I want yet, I am determined to learn and get better. I'm digging the whole lathering thing, I feel like I am treating myself to a luxury I never knew existed. I look forward to shaving after nearly 25 plus years of dreading the chore! Who knew?
    MickR, pfries and Vegita182 like this.

  2. #2
    Senior Member billyc4362's Avatar
    Join Date
    Aug 2013
    Location
    Philadelphia, PA
    Posts
    139
    Thanked: 5

    Default

    Captains Log- Supplemental:

    After watching yet another video on youtube I have discovered that the way I was holding the razor was the culprit for my nicks, as well as the improper angle. I have large fingers and was struggling for a good grip. I now place only my pinkie on the tang, (I can only fit one finger on it anyway) place the ring and and middle finger on the shank, and the index finger out on the spine. Spock had warned me that it was "Illogical" to place a sharp piece of steel
    in close proximity to my face. I noted his protest in the Ships log and proceeded to attempt this new razor grip. I did a few dry strokes on places where I had stubble, and I was met with success! I feel I have better control over the razor! I can boldly go where no cartridge razor has shaved before!

    -Kirk out!
    MickR, pfries and edhewitt like this.

  3. #3
    May your bone always be well buried MickR's Avatar
    Join Date
    Jun 2010
    Location
    Brisbane/Redcliffe, Australia
    Posts
    6,380
    Thanked: 983

    Default

    Keep up the good work...Just remember to stop when 'she cannae take it anymore Cap'n'.


    Mick
    edhewitt likes this.

  4. The Following User Says Thank You to MickR For This Useful Post:

    billyc4362 (08-19-2013)

  5. #4
    A Fully-Fleshed Brethren Brenngun's Avatar
    Join Date
    May 2013
    Location
    Toronto, Canada
    Posts
    629
    Thanked: 130

    Default

    Technique wins over all.
    Keep your concentration high and your angles low!

    Despite the high cost of living, it's still very popular.

  6. #5
    Senior Member Alembic's Avatar
    Join Date
    Dec 2009
    Location
    Clarkston MI
    Posts
    1,527
    Thanked: 488
    Blog Entries
    1

    Default

    Here is something that might help you. I start with my razor flat and lift into the stroke, modifying the angle as I go through contours. I have found that it is really easy to pick an angle that is too obtuse becaue of our experience with the razors of the past.

    Also, I have found that there is no advnatage for me to start at say the top of my cheek and run the stroke all the way down my neck or even to my jaw line. I use short 1/4 to 1/2" overlapping strokes as I move through the pass. Many people do. The advantage is that you have more control over the blade, more opportunity for course correction, and if you do manage to get a cut going, you willnot have momentum to exacerbate the cut an make it longer.

    Just some things to try - and keep it up. It is very rewarding when you get it down.

  7. The Following User Says Thank You to Alembic For This Useful Post:

    billyc4362 (08-20-2013)

  8. #6
    Senior Member billyc4362's Avatar
    Join Date
    Aug 2013
    Location
    Philadelphia, PA
    Posts
    139
    Thanked: 5

    Default

    Let me get a little clarification- are you saying you dont start at the top of your cheek, or are you saying you start there but dont do long strokes downward?

  9. #7
    Senior Member Alembic's Avatar
    Join Date
    Dec 2009
    Location
    Clarkston MI
    Posts
    1,527
    Thanked: 488
    Blog Entries
    1

    Default

    The second one. But it really doesn't matter which direction or the starting point. Wherever you are headed don't try and get there in one long pass. Short overlapping controlled strokes work the beat for many of us. Give it a try.
    edhewitt likes this.

  10. The Following User Says Thank You to Alembic For This Useful Post:

    billyc4362 (08-20-2013)

  11. #8
    Senior Member billyc4362's Avatar
    Join Date
    Aug 2013
    Location
    Philadelphia, PA
    Posts
    139
    Thanked: 5

    Default

    Great tip! I have been doing long strokes and only stopping when the blade fills up with lather. I will definitely give that a shot!
    edhewitt likes this.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •