Search:

I think I have nothing to lose.
Now... what to use as an insert? I like what you have done with the brass piece.

My idea was to just replace the scales with some pre made ones, made from the same material. I ditched the wooden scales early on as I do not have a workshop. I also like the simple clean look of...

The Chabaz scales are also a bit warped in the silver inlay area
320371
320372

Nice job! What did you use as epoxy filler?

It was a bit difficult to sand the wedge, but it worked in the end.
I've tighten the pin and it actually required harder tapping than what I expected. I am happy with the result, but a bit of...

Thank you for all the info!
I have decided that I will not repin it. I will just rotate the wedge and file the corner off. I think less than one milimeter will do. After that I am tempted to tighten...

The wedge is exactly like in my drawing - rather sure that is the wrong way around.
It is slightly lose and I can rotate it a little bit. I could rotate it and then file it. I do not have a file...

Hi guys, it's been a while since my last post. I want to start working on this razor:
319784

The wedge is upside down and I would like to flip it around. Is there anything I should know before...